CPS

Hardware Design Training

We do offer specialized Hardware Design Training to freshers & working professionals.

Course Outline:

  • Introduction to Board Design
  • Introduction to electronic components resistors, capacitors, inductors, transistors, PLD, FPGA and Processor
  • Component Identification and selection for the requirement
  • Clocking Design
  • Power supply conversion
  • Basics of AC to DC
  • Basics of DC to DC
  • Digital I/O
  • I/O standards
  • Buffers/Drivers/Level Translators
  • Analog I/O
  • Basics of ADC and DAC
  • Introduction to Processor based system
  • Introduction to FPGA based system
  • Memory Interface
  • SRAM
  • Flash/EPROM
  • SDRAM
  • DDR/DDR2/DDR3/DDR4
  • Serial communication Interface
  • UART
  • SPI
  • I2C
  • Introduction to Board bring up
  • Introduction to Oscilloscope and Probe Basics
  • Introduction to Signal Measurements and Board Validation
  • Basic Timing Analysis
  • Power Analysis
  • Introduction to Signal Integrity
  • Schematic Entry
  • BOM creation

PCB CAD Layout Design

  • PCB Stack up creation
  • Layout Guideline
  • Fabrication Guidelines and Gerber Release
  • Fabrication process
  • Assembly process
  • Lab Ethics (Procedure for Safety – ESD, Power sequence etc)
  • Testing - Test and Measurement equipments
  • Test Report preparation

"For training requirement, contact us at This email address is being protected from spambots. You need JavaScript enabled to view it."